Languages:  English  
Currencies:  


FREE SHIPPING
on all orders over $50.00

ELO E658721 CTR-221600-AT-RSU-00R 2216 ACCUTOUCH SERIAL USB HUB

£59.00

Add to Cart:



  • Model: ELO E658721 CTR-221600-AT-RSU-00R 2216 ACCUTOUCH SERIAL USB HUB
  • Shipping Weight: 0.2lbs
  • 44 Units in Stock
  • Manufactured by: Elo

ELO E658721 CTR-221600-AT-RSU-00R 2216 ACCUTOUCH SERIAL USB HUB CONTROLLER BOARD 615rt
• (1) - USB INPUT BOARD
on the bezel less touch panels these are a common failure in j2 systems


E271-2210, 2210MX, 140, 3000U

 

Supply Voltage and Current
•+5 VDC, nominal (+4.50 VDC to +5.25 VDC). Self powered only.
•50 mA standby, typical at +5 VDC; during touch 160 mA average, 240 mA peak
•Average power dissipation is 0.5 W, typical
•Supply must be capable of sourcing 400 mA, minimum
•Total noise and ripple requirement must be less than 100mV (p-p) for frequencies below 1MHz, and less than 50mV (p-p) for frequencies above 1MHz.

Interface-Serial
•EIA 232E (Serial RS-232), DCE configuration. 8 Data Bits, 1 Stop Bit, No Parity, Full Duplex
•Hardware handshaking: RTS/CTS
•DSR is pulled HIGH (>+3V) by the 2216 when connected and powered. DTR can be asserted by the host to interrupt the flow of data from the controller.
•Note that if the application does not monitor CTS, then an interval of approximately 5 seconds should be inserted between the issuance of a reset command and any other command.

Communication Parameters
•Baud Rate 9600 (default), and 19200
•8 Data bits, 1 stop bit, no parity only

Interface-USB
•The 2216 is a full-speed USB device. If the USB is connected to the controller, the controller will communicate over the USB, and will not communicate over the serial port.
•The 2216 is never powered from the USB û it is self-powered only.

Operating Modes
•Full AccuTouch SmartSet protocol. Emulation of E281A-4002 protocol can be selected by SmartSet command.
•Initial/ Stream/ Untouch/ Z-axis Enable Modes

Touch Resolution

•4096x4096, size independent


Conversion Time
•Approximately 10 ms per coordinate set

LED Diagnostic Characteristics

A green LED indicates controller status as below:

LED Blink Rate Function
Once per second Normal condition, untouched state
On continuously Touched state
Twice per second Error detected



Elo Part Number CTR-221600-AT-RSU-00R CTR221600ATRSU00R


if your touch screen isnt working it may be the controller or the touch or the mainboard

we have other repair options if in doubt just send it into us for repair rather than gambling on the cost of the part




This product was added to our catalog on Tuesday 19 June, 2018.