NL10276BC20-08 26cm (10.4 Type) XGA LVDS Interface (1 port)
datasheet at http://www.pointosale.co.uk/datasheets/NL10276BC20-08.pdf
Display area 210.432 (H) � 157.824 (V) mm
Diagonal size of display 26 cm (10.4 inches)
Drive system a-Si TFT active matrix
Display color 262,144 colors (6-bit)
Pixel 1,024 (H) � 768 (V) pixels
Pixel arrangement RGB (Red dot, Green dot, Blue dot) vertical stripe
Dot pitch 0.0685 (H) � 0.2055 (V) mm
Pixel pitch 0.2055 (H) � 0.2055 (V) mm
Module size 227.0 (W) � 174.5 (H) � 10.5 (D) mm (typ.)
Weight 440 g (typ.)
Contrast ratio 700:1 (typ.)
Viewing angle
At the contrast ratio ≥10:1
� Horizontal: Right side 85� (typ.), Left side 85� (typ.)
� Vertical: Up side 85� (typ.), Down side 85� (typ.)
Designed viewing direction At DPS = Low or Open: Normal scan
� Viewing angle with optimum grayscale (γ=2.2): normal axis
Polarizer surface Clear
Polarizer pencil-hardness 3H (min.) [by JIS K5400]
Color gamut At LCD panel center
40 % (typ.) [against NTSC color space]
Response time Ton+Toff (10%←→ 90%)
25 ms (typ.)
Luminance At IBL= 5.0mArms / lamp
300 cd/m2 (typ.)
Signal system
LVDS interface (1port)
6-bit digital signals for data of RGB colors,
Dot clock (CLK), Data enable (DE)
Power supply voltage LCD panel signal processing board: 3.3V
Backlight
Edge light type: 2 cold cathode fluorescent lamps
Replaceable parts
� Lamp holder set: Type No. 104LHS44
Recommended inverter (Option)
� Inverter: Type No. 104PW191
Power consumption At IBL= 5.0mArms / lamp, Checkered flag pattern
6.7 W (typ., Power dissipation of the inverter is not included.)
Pin No. Symbol Signal Remarks
1 N.C. No connection
2 N.C. No connection
Keep this pin Open.
3 DPS Selection of scan direction High: Reverse scan
Low or Open: Normal scan Note1
4 N.C. No connection Keep this pin Open.
5 GND Ground Note2
6 CLK+
7 CLKPixel
clock Note3
8 GND Ground Note2
9 D2+
10 D2-
Pixel data Note3
11 GND Ground Note2
12 D1+
13 D1-
Pixel data Note3
14 GND Ground Note2
15 D0+
16 D0-
Pixel data Note3
17 GND
18 GND
Ground Note2
19 VCC
20 VCC
Power supply Note2
Note1: See "4.8 SCANNING DIRECTIONS".
Note2: All GND and VCC terminals should be used without any non-connected lines.
Note3: Twist pair wires with 100Ω (Characteristic impedance) should be used between LCD panel
signal processing board and LVDS transmitter.
Note4: See "4.5.4 Connection between receiver and transmitter for LVDS".
